This bracket allows you to mount a ZWO Electronic Automatic Focuser (EAF)
onto your telescope.
The system consists of two parts: a bracket for your telescope
and a coupler that attaches the EAF onto the focuser pinion. Connections
are held securely with stainless steel M3 set screws. Where necessary,
bracket mounting screws are provided. The ZWO supplied M4 screws
are used to attach the EAF to the bracket. Note that the user will need
to have a 1.5mm hex key for the M3 set screws (not provided).
EAF-FTF30 : ZWO EAF bracket for Feathertouch refractor focusers. Confirmed fit with FTF30xx and FTF32xx. Will likely fit FTF25xx.
EAF-FTM-SCT : ZWO EAF bracket for the Feathertouch Micro
EAF-FTM-TVis : Known to fit the Feathertouch PIN-20FT focuser on a TV60is. This bracket may also fit the PIN-24FT focuser, but is untested.
EAF-C5 : ZWO EAF bracket for the Celestron C5
EAF-C6.8.9.25-RASA8 : ZWO EAF bracket for modern Celestron C6/C8/C9.25/RASA8 scopes that have 27mm between focuser mounting screws.
EAF-C11.14-RASA11 : ZWO EAF bracket for modern Celestron C11/C14/RASA11 scopes that have 27mm between focuser mounting screws.
EAF-C6.8.9.25-Classic : ZWO EAF bracket for classic Celestron C6/C8/C9.25 scopes that have 23mm between focuser mounting screws.
EAF-MLXGPS : ZWO EAF bracket for Meade LX200GPS scopes.
EAF-MLXACF : ZWO EAF bracket for Meade LX200ACF scopes.
EAF-MLXClassic : ZWO EAF bracket for Classic Meade LX200 scopes.
EAF-GSO-2LBF : ZWO EAF bracket for the GSO 2" Linear Bearing Focuser/TS Monorail. See mounting instructions below.
EAF-GSO-3.25LBF : ZWO EAF bracket for the GSO 3.25" Linear Bearing Focuser. See mounting instructions below.
EAF-GSO-2CRF-M : ZWO EAF bracket for the GSO 2" Crayford dual speed focuser.
See pictures for illustrations of "modern" vs "classic" Celestron focuser
mounting brackets.
GSO Linear Bearing Focuser EAF Bracket Mounting Instructions:
Please follow carefully!
1. With the bottom of the focuser pointing up to avoid falling,
remove the 4 screws.
2. Place the EAF bracket on the focuser and using the screws provided
evenly tighten all 4 screws until they are snug. Tighten 1/4 turn
more, being careful to tighten all 4 screws evenly.
3. Slide the coupler onto the focuser pinion shaft.
4. Attach the EAF to the bracket.
5. Tighten the set screws on the coupler. Do not over tighten.
If you don't see a bracket that meets your needs I would be glad to work with you to come up with a solution.
Color Note: The coupler will be black due to the special filament used for the coupler. The bracket can be black, red or silver.
Priority shipping available also. International shipping calculated at checkout. Please see the shipping tab for more info.
Feather Touch Focuser Brackets :
Celestron and Meade SCT Brackets :
Other Focuser Brackets:
Printed in durable, temperature tolerant PETG filament.